Rosanne Tran Armchair September 04th, 2018 - 15:53:22
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
For a smaller space, this really is crucial. You want to be sure to have enough room to sit down comfortably in the chair, while also ensuring it fits in the area. The smallest you need to look at for seat depth (or inner measurements) is approximately 24 inches wide for comfortable seating. Take external sizes too, so you will know your chair will slot in perfectly to the space you've got reserved for it.
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.
It is possible to have cushions made up for you by professionals, but they are easy to make yourself from rubber and the covering of your choice.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Laundry hamper area rugs baby blanket pillow storage bench sleeper sofa recling sofa best sectional sofa landscape lighting vanity lights lava lamps table runner best tv stand.