Alexandra Stokes Armchair November 06th, 2018 - 09:27:44
This chair has a very simple construction. It consists simply of four panels which slot together to give a stable assembly. Despite its simplicity, its lines are as stylish as any manufactured chair and will complement any living room.
As a result, we're sometimes forced to poke at devices in the dark, all while finding brightness settings that strike the delicate balance between readability and how much it disturbs our sleeping partners. We could always move off the bed, but what's more comfortable than a bed in a bedroom? An armchair could be a close second. It's a wonder more people don't have comfortable seating in their bedrooms for this very scenario.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
One answer to the problem, which has been developed over the last few years, is furniture which can easily and quickly be stowed away when not in use. Nowadays it is possible to buy inflatable chairs, and more conventional chairs which can be assembled or dismantled in a matter of seconds. It is on this latter principle that the knock-down chair has been designed.
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Comforter sets candle holders wool blanket pillow storage shed chaise lounge ottoman chair sectional sofa porch swings salt lamps lava lamps table runner 43 inch tv stand.