Evangeline Duffy Armchair July 07th, 2018 - 00:35:39
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
One answer to the problem, which has been developed over the last few years, is furniture which can easily and quickly be stowed away when not in use. Nowadays it is possible to buy inflatable chairs, and more conventional chairs which can be assembled or dismantled in a matter of seconds. It is on this latter principle that the knock-down chair has been designed.
The size of a chair needs to be taken into consideration when you don't have a great deal of room to manoeuvre. When you are considering armchairs for small spaces you might consider a smaller version of a standard chair. This should be between 24 inches and 32 inches wide - usually ample room to allow somebody to be seated comfortably. Never leave sizing to chance, hoping that it will slot into that rather neat little place you have planned for it. You need to be ruthless with measurements - make sure you measure the space you have and the furniture you want to fill it with.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
If you trawl through the enormous array of different styles that the various manufacturers, you may notice that most armchairs seem to lack in originality. The problem with many designers is they seem to forget people have to sit in the chairs and it's the act of sitting that inspires the design of the chair... not the other way around. Furthermore, the armchair is designed to be sat in with comfort in mind: where backs, buttocks and arms should be supported ergonomically to take the pressure off the muscles across the shoulders and lower neck.