Brittney Vinson Armchair September 04th, 2018 - 19:55:15
This chair has a very simple construction. It consists simply of four panels which slot together to give a stable assembly. Despite its simplicity, its lines are as stylish as any manufactured chair and will complement any living room.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.
Planning your decor according to the size of your space is critical, no matter whether the room is large or small. Home furniture needs some space in between it to ensure proper room flow, traffic flow and safety.
Wood is used for the basic frame. Pine or some other softwood is suitable, but a satisfactory and cheaper alternative is 16mm plywood. As with most manufactured materials, there are different grades of plywood and you should choose a high quality type, such as Finnish birch, which takes a very good painted finish on both surfaces.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Bathroom light candle holders wool blanket pillow patio table sleeper sofa ottoman chair sectional sofa landscape lighting salt lamps neon signs table runner best tv stand.