Marta Lowery Armchair September 04th, 2018 - 10:46:05
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides.
It is possible to have cushions made up for you by professionals, but they are easy to make yourself from rubber and the covering of your choice.
One answer to the problem, which has been developed over the last few years, is furniture which can easily and quickly be stowed away when not in use. Nowadays it is possible to buy inflatable chairs, and more conventional chairs which can be assembled or dismantled in a matter of seconds. It is on this latter principle that the knock-down chair has been designed.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
When choosing armchairs for small spaces you need to ensure the size of those armchairs don't dominate the overall proportions of the room they are intended for. It's not just the size either, but the style that you need to be careful of. When choosing armchairs for small spaces, ensure you choose armchairs with thin arms, freestanding legs rather than legs that are hidden by flaps of upholstery. And when it is a choice between curves and straight lines, forget about the curves - when you want to fit armchairs for small spaces, always go for clean straight lines. You may even consider choosing armchairs with no arms at all - that is bound to save you some space, albeit not a great deal but it will also trick the eye into believing there's more than there is.
Wood is used for the basic frame. Pine or some other softwood is suitable, but a satisfactory and cheaper alternative is 16mm plywood. As with most manufactured materials, there are different grades of plywood and you should choose a high quality type, such as Finnish birch, which takes a very good painted finish on both surfaces.