Meagan Talley Armchair September 02nd, 2018 - 12:47:28
A continuing trend in modern furniture design has been the sacrificing of comfort for economy and space. While agreeing that those huge Victorian armchairs were really luxurious, designers today would argue that they would be very much out of place in a modern house, as well as being inordinately expensive. So, designers concentrate on producing chairs which can easily be mass produced and which fit contemporary tastes. Unfortunately of course, the result of such thinking is that most chairs manufactured now tend to merely ornament a room without being very comfortable.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
The chair itself has to be in comparative proportion to your room you're placing it in. If you've got a large area, with heavy furniture, then a compact, thin-armed chair will appear delicate and out of place. If you've got a small room, then an armchair that's got thick arms and curved features will overpower all of your furniture. Either way, a room will appear and feel off-balance.
Perhaps the greatest limitation on furniture design is the smallness of modern houses. To be comfortable, a chair must not only be well designed, constructed and padded, but also it must be fairly large. As few people can afford the space for a large suite of furniture, armchairs become increasingly smaller.
First tale the two side panels and cut out the angled rear edge. To do this accurately, mark a line 25mm from the rear edge, then draw a line diagonally from opposite corners. Provided your two side panels match exactly in size, you can clamp them together and cut along the diagonal line to give a matching pair.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Comforter sets console table wool blanket neck pillow patio table chaise with sleeper ottoman table sectional sofa landscape lighting salt lamps lite neon signs best table runner 43 inch tv stand.