Terri Drake Armchair August 28th, 2018 - 02:57:31
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
Many of the armchairs don't do that and many have seats at the wrong angle. Making it completely uncomfortable to sit in. However, a few manufacturers seem to take comfort, style and size into consideration. And from these few, it's possible to choose some that are not only suitable sized armchairs for small spaces but ones that evince plenty of real style as well.
The size of a chair needs to be taken into consideration when you don't have a great deal of room to manoeuvre. When you are considering armchairs for small spaces you might consider a smaller version of a standard chair. This should be between 24 inches and 32 inches wide - usually ample room to allow somebody to be seated comfortably. Never leave sizing to chance, hoping that it will slot into that rather neat little place you have planned for it. You need to be ruthless with measurements - make sure you measure the space you have and the furniture you want to fill it with.
For a smaller space, this really is crucial. You want to be sure to have enough room to sit down comfortably in the chair, while also ensuring it fits in the area. The smallest you need to look at for seat depth (or inner measurements) is approximately 24 inches wide for comfortable seating. Take external sizes too, so you will know your chair will slot in perfectly to the space you've got reserved for it.
One answer to the problem, which has been developed over the last few years, is furniture which can easily and quickly be stowed away when not in use. Nowadays it is possible to buy inflatable chairs, and more conventional chairs which can be assembled or dismantled in a matter of seconds. It is on this latter principle that the knock-down chair has been designed.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.