Jennifer Kirkland Armchair August 09th, 2018 - 16:57:48
Provided both side panels have been cut to exactly the same size, there is no reason why you should not clamp them together with all edges flush and cut out paired slots at the same time.
Some of the most comfortable furniture pieces are the ones that have been in your home for several generations. They exude a welcoming and lived-in ambiance to which people easily resonate. A rococo armchair in the living room may resemble the chair that your great grandmother sat on in the black and white photograph hanging on the wall of memories. This brings a vivid sense of nostalgia that compels you to look back to the past. Furniture pieces made long ago have a valuable history attached to them. Resting in an antique armchair that was passed down through several generations, you can let your imagination take you away to those earlier times and make connections with those who sat upon that very chair as the decades passed.
One answer to the problem, which has been developed over the last few years, is furniture which can easily and quickly be stowed away when not in use. Nowadays it is possible to buy inflatable chairs, and more conventional chairs which can be assembled or dismantled in a matter of seconds. It is on this latter principle that the knock-down chair has been designed.
A continuing trend in modern furniture design has been the sacrificing of comfort for economy and space. While agreeing that those huge Victorian armchairs were really luxurious, designers today would argue that they would be very much out of place in a modern house, as well as being inordinately expensive. So, designers concentrate on producing chairs which can easily be mass produced and which fit contemporary tastes. Unfortunately of course, the result of such thinking is that most chairs manufactured now tend to merely ornament a room without being very comfortable.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides.
First tale the two side panels and cut out the angled rear edge. To do this accurately, mark a line 25mm from the rear edge, then draw a line diagonally from opposite corners. Provided your two side panels match exactly in size, you can clamp them together and cut along the diagonal line to give a matching pair.