Kathie Hendrix Armchair August 13th, 2018 - 04:55:41
Be it an email you just need to send that night, or some last minute present buying or travel arrangements, our lives are increasingly ruled by devices, and at the same time, we're increasingly expected to be accessible and available all hours of the day.
If you trawl through the enormous array of different styles that the various manufacturers, you may notice that most armchairs seem to lack in originality. The problem with many designers is they seem to forget people have to sit in the chairs and it's the act of sitting that inspires the design of the chair... not the other way around. Furthermore, the armchair is designed to be sat in with comfort in mind: where backs, buttocks and arms should be supported ergonomically to take the pressure off the muscles across the shoulders and lower neck.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
The armchair in the bedroom helps with a very 21st century issue - the quandary of laptop, tablet or phone use in bed while your partner is trying to sleep.