Kathie Hendrix Armchair September 07th, 2018 - 00:57:57
Some of the most comfortable furniture pieces are the ones that have been in your home for several generations. They exude a welcoming and lived-in ambiance to which people easily resonate. A rococo armchair in the living room may resemble the chair that your great grandmother sat on in the black and white photograph hanging on the wall of memories. This brings a vivid sense of nostalgia that compels you to look back to the past. Furniture pieces made long ago have a valuable history attached to them. Resting in an antique armchair that was passed down through several generations, you can let your imagination take you away to those earlier times and make connections with those who sat upon that very chair as the decades passed.
A continuing trend in modern furniture design has been the sacrificing of comfort for economy and space. While agreeing that those huge Victorian armchairs were really luxurious, designers today would argue that they would be very much out of place in a modern house, as well as being inordinately expensive. So, designers concentrate on producing chairs which can easily be mass produced and which fit contemporary tastes. Unfortunately of course, the result of such thinking is that most chairs manufactured now tend to merely ornament a room without being very comfortable.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
Provided both side panels have been cut to exactly the same size, there is no reason why you should not clamp them together with all edges flush and cut out paired slots at the same time.
A great rule of thumb is the fact that the bigger your space, the 'heavier' your armchair could be (and the other way round). A study covered with walls of book shelves and wood panels can accommodate a heavy, dominating chair. Look at armchairs for sale who have rich detailing and more classic design. For a more modern space, especially a smaller space, look for free standing legs and slimmer arm rests, and straight, clean lines.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Bathroom light area rugs blanket neck pillow patio table chaise lounge recling sofa sectional sofa porch swings salt lamps lava lamps best table runner 43 inch tv stand.