Faye Poole Armchair July 06th, 2018 - 13:37:47
A great rule of thumb is the fact that the bigger your space, the 'heavier' your armchair could be (and the other way round). A study covered with walls of book shelves and wood panels can accommodate a heavy, dominating chair. Look at armchairs for sale who have rich detailing and more classic design. For a more modern space, especially a smaller space, look for free standing legs and slimmer arm rests, and straight, clean lines.
As for the well-lit study suggestion, appealing though it sounds to work under the sun without contending with sudden winds, nothing renders a computer screen unreadable as quickly as sunlight shining directly onto it. Before you know it you've closed so many blinds to block out the sun you've taken away all of the benefits of the conservatory in the first place.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides.
We can be ever so rigid in our thinking at times. Armchairs and sofas go in the living room, don't they? That's where they've always gone. That's where we relax in front of the TV, open Christmas presents, and have lazy evening takeaways when we can't muster the energy to set up the dining room. It's where we entertain and relax.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.