Toni Velez Armchair August 31st, 2018 - 05:46:55
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
The important fact that you have to consider is the function that the room will involve. It means that if the room is such which will be utilized for frequent movements then it is better to buy an armchair that is not to bulky as shifting it from one place to another will be problematic. The position of reclining is also important that is if you want an armchair that should give support to your head then choose an upright armchair with hand rest.
Planning out your space is absolutely crucial when you are living in a small space. For safety you need to allocate a safe space between articles of furniture. In the case of between chairs and the sofa, a space of between 2 to 3 feet should be adequate to prevent hitting the exterior against the furniture every time you move. You also need to have a minimum of 2 foot between the front of your chair or sofa and your coffee table to allow you sufficient room when you stand up. You don't really want to overbalance and keel over across the coffee table if you lose your balance!
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
A vacant space under a set of stairs can easily be transformed into a reading area with the addition of an armchair, and little else. It's a simple, cost-effective change - no shelving, carpeting and so on necessary. You just need to fit in with the colour scheme of your hall.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.