Rosanne Tran Armchair August 28th, 2018 - 07:43:25
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
We can be ever so rigid in our thinking at times. Armchairs and sofas go in the living room, don't they? That's where they've always gone. That's where we relax in front of the TV, open Christmas presents, and have lazy evening takeaways when we can't muster the energy to set up the dining room. It's where we entertain and relax.
In the modern trend the armchair has become an important piece of furniture along with the sofa and other furniture that you buy to decorate your house. Purchasing the armchair requires special consideration as it will not only add to the beauty of the room but will also provide comfort and relaxation when you recline in it to watch your favorite show on the television or read the newspaper or just relax after a tiring day.
The chair itself has to be in comparative proportion to your room you're placing it in. If you've got a large area, with heavy furniture, then a compact, thin-armed chair will appear delicate and out of place. If you've got a small room, then an armchair that's got thick arms and curved features will overpower all of your furniture. Either way, a room will appear and feel off-balance.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Bath rugs floating shelves baby blanket travel pillow storage bench sleeper sofa recling sofa sectional sofa landscape lighting salt lamps lite neon signs best table runner tv stand.