Shelby Mann Armchair July 06th, 2018 - 23:44:53
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
You also need to ensure that you measure the outer dimensions of a piece of furniture - when you are limited for space, it is the outer dimensions that are going to be the important ones. It is as well to remember that whatever the outer measurements of your armchair are, the interior measurements are going to be smaller - so make sure you will have enough room to actually be comfortable when sitting in the armchair.
It is possible to have cushions made up for you by professionals, but they are easy to make yourself from rubber and the covering of your choice.
The important fact that you have to consider is the function that the room will involve. It means that if the room is such which will be utilized for frequent movements then it is better to buy an armchair that is not to bulky as shifting it from one place to another will be problematic. The position of reclining is also important that is if you want an armchair that should give support to your head then choose an upright armchair with hand rest.
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.