Marla Flowers Armchair July 06th, 2018 - 22:57:58
A vacant space under a set of stairs can easily be transformed into a reading area with the addition of an armchair, and little else. It's a simple, cost-effective change - no shelving, carpeting and so on necessary. You just need to fit in with the colour scheme of your hall.
First tale the two side panels and cut out the angled rear edge. To do this accurately, mark a line 25mm from the rear edge, then draw a line diagonally from opposite corners. Provided your two side panels match exactly in size, you can clamp them together and cut along the diagonal line to give a matching pair.
Conservatories are difficult to contend with, furniture-wise. Do you make the conservatory a secondary summer dining area, a bright working space, or a living room without a TV?
Wood is used for the basic frame. Pine or some other softwood is suitable, but a satisfactory and cheaper alternative is 16mm plywood. As with most manufactured materials, there are different grades of plywood and you should choose a high quality type, such as Finnish birch, which takes a very good painted finish on both surfaces.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.