Home / Armchair / Dorel Living Reva Accent Chair / Dorel Living Reva Accent Chair With Dorel Living Reva Accent Chair Blue Plus Dorel Living Reva Accent Chair Gray Together With Dorel Living Reva Accent Chair
Faye Poole Armchair September 05th, 2018 - 03:01:28
Some of the most comfortable furniture pieces are the ones that have been in your home for several generations. They exude a welcoming and lived-in ambiance to which people easily resonate. A rococo armchair in the living room may resemble the chair that your great grandmother sat on in the black and white photograph hanging on the wall of memories. This brings a vivid sense of nostalgia that compels you to look back to the past. Furniture pieces made long ago have a valuable history attached to them. Resting in an antique armchair that was passed down through several generations, you can let your imagination take you away to those earlier times and make connections with those who sat upon that very chair as the decades passed.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
It is possible to have cushions made up for you by professionals, but they are easy to make yourself from rubber and the covering of your choice.
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
The important fact that you have to consider is the function that the room will involve. It means that if the room is such which will be utilized for frequent movements then it is better to buy an armchair that is not to bulky as shifting it from one place to another will be problematic. The position of reclining is also important that is if you want an armchair that should give support to your head then choose an upright armchair with hand rest.
Provided both side panels have been cut to exactly the same size, there is no reason why you should not clamp them together with all edges flush and cut out paired slots at the same time.