Terry Albert Armchair July 07th, 2018 - 00:12:02
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
The important fact that you have to consider is the function that the room will involve. It means that if the room is such which will be utilized for frequent movements then it is better to buy an armchair that is not to bulky as shifting it from one place to another will be problematic. The position of reclining is also important that is if you want an armchair that should give support to your head then choose an upright armchair with hand rest.
We can be ever so rigid in our thinking at times. Armchairs and sofas go in the living room, don't they? That's where they've always gone. That's where we relax in front of the TV, open Christmas presents, and have lazy evening takeaways when we can't muster the energy to set up the dining room. It's where we entertain and relax.
Conservatories are difficult to contend with, furniture-wise. Do you make the conservatory a secondary summer dining area, a bright working space, or a living room without a TV?