Kathy Albert Armchair October 31st, 2018 - 19:21:51
Provided both side panels have been cut to exactly the same size, there is no reason why you should not clamp them together with all edges flush and cut out paired slots at the same time.
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
The size of a chair needs to be taken into consideration when you don't have a great deal of room to manoeuvre. When you are considering armchairs for small spaces you might consider a smaller version of a standard chair. This should be between 24 inches and 32 inches wide - usually ample room to allow somebody to be seated comfortably. Never leave sizing to chance, hoping that it will slot into that rather neat little place you have planned for it. You need to be ruthless with measurements - make sure you measure the space you have and the furniture you want to fill it with.
One answer to the problem, which has been developed over the last few years, is furniture which can easily and quickly be stowed away when not in use. Nowadays it is possible to buy inflatable chairs, and more conventional chairs which can be assembled or dismantled in a matter of seconds. It is on this latter principle that the knock-down chair has been designed.
From where I'm sitting, using it as a summer dining area seems unnecessary. Your summer dining area will be your garden or patio if you have the space, and if the weather is good enough, so why would you need what is effectively a tertiary dining area?
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Comforter sets floating shelves blanket travel pillow patio table chaise lounge ottoman chair sectional sofa landscape lighting best vanity lights neon signs black table runner best tv stand.