Faye Poole Armchair November 19th, 2018 - 00:26:58
While the rich and famous might have the space for a thirty-seating cinema in their basement, the rest of us don't. So the rows of plush cinema seating that the stars have aren't really of any use to us. A handful of armchairs would neatly achieve the same objective, though.
A continuing trend in modern furniture design has been the sacrificing of comfort for economy and space. While agreeing that those huge Victorian armchairs were really luxurious, designers today would argue that they would be very much out of place in a modern house, as well as being inordinately expensive. So, designers concentrate on producing chairs which can easily be mass produced and which fit contemporary tastes. Unfortunately of course, the result of such thinking is that most chairs manufactured now tend to merely ornament a room without being very comfortable.
Planning your decor according to the size of your space is critical, no matter whether the room is large or small. Home furniture needs some space in between it to ensure proper room flow, traffic flow and safety.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Bath math floating shelves wool blanket neck pillow storage shed chaise lounge ottoman chair sectional sofa porch swings salt lamps lite neon signs black table runner tv stand.