Marla Flowers Armchair September 06th, 2018 - 15:31:14
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
Wood is used for the basic frame. Pine or some other softwood is suitable, but a satisfactory and cheaper alternative is 16mm plywood. As with most manufactured materials, there are different grades of plywood and you should choose a high quality type, such as Finnish birch, which takes a very good painted finish on both surfaces.
A great rule of thumb is the fact that the bigger your space, the 'heavier' your armchair could be (and the other way round). A study covered with walls of book shelves and wood panels can accommodate a heavy, dominating chair. Look at armchairs for sale who have rich detailing and more classic design. For a more modern space, especially a smaller space, look for free standing legs and slimmer arm rests, and straight, clean lines.
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
The size of a chair needs to be taken into consideration when you don't have a great deal of room to manoeuvre. When you are considering armchairs for small spaces you might consider a smaller version of a standard chair. This should be between 24 inches and 32 inches wide - usually ample room to allow somebody to be seated comfortably. Never leave sizing to chance, hoping that it will slot into that rather neat little place you have planned for it. You need to be ruthless with measurements - make sure you measure the space you have and the furniture you want to fill it with.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Comforter sets area rugs baby blanket travel pillow patio table chaise with sleeper ottoman table sectional sleeper sofa porch swings best salt lamps neon signs black table runner best tv stand.