Imelda Roy Armchair July 06th, 2018 - 23:52:48
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
You also need to ensure that you measure the outer dimensions of a piece of furniture - when you are limited for space, it is the outer dimensions that are going to be the important ones. It is as well to remember that whatever the outer measurements of your armchair are, the interior measurements are going to be smaller - so make sure you will have enough room to actually be comfortable when sitting in the armchair.
Planning your decor according to the size of your space is critical, no matter whether the room is large or small. Home furniture needs some space in between it to ensure proper room flow, traffic flow and safety.
Why restrict ourselves, though? There are a number of rooms that armchairs would easily fit into, and in fact, there are a number of use cases that are crying out for armchairs above all else. With handcrafted furniture companies (see below for an example), you have ample options to tailor an armchair to those specific environments. No need to worry about your armchair looking like it's been pulled straight out of the living room and is being held somewhere else temporarily.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.