Priscilla Farmer Armchair August 12th, 2018 - 17:19:37
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides.
First tale the two side panels and cut out the angled rear edge. To do this accurately, mark a line 25mm from the rear edge, then draw a line diagonally from opposite corners. Provided your two side panels match exactly in size, you can clamp them together and cut along the diagonal line to give a matching pair.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
The important fact that you have to consider is the function that the room will involve. It means that if the room is such which will be utilized for frequent movements then it is better to buy an armchair that is not to bulky as shifting it from one place to another will be problematic. The position of reclining is also important that is if you want an armchair that should give support to your head then choose an upright armchair with hand rest.
It is possible to have cushions made up for you by professionals, but they are easy to make yourself from rubber and the covering of your choice.