Home / Armchair / Matching Accent Chairs / Matching Accent Chairs And Pillows Matching Accent Chairs Matching Occasional Chairs Matching Accent Chair And Ottoman

Matching Accent Chairs And Pillows Matching Accent Chairs Matching Occasional Chairs Matching Accent Chair And Ottoman

Terry Albert Armchair November 03rd, 2018 - 22:39:02

Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
A vacant space under a set of stairs can easily be transformed into a reading area with the addition of an armchair, and little else. It's a simple, cost-effective change - no shelving, carpeting and so on necessary. You just need to fit in with the colour scheme of your hall.

Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.

You also need to ensure that you measure the outer dimensions of a piece of furniture - when you are limited for space, it is the outer dimensions that are going to be the important ones. It is as well to remember that whatever the outer measurements of your armchair are, the interior measurements are going to be smaller - so make sure you will have enough room to actually be comfortable when sitting in the armchair.
Provided both side panels have been cut to exactly the same size, there is no reason why you should not clamp them together with all edges flush and cut out paired slots at the same time.
While many of us watched MTV Cribs bursting with jealousy and loathing, some of us might have seen the cinema rooms in a number of celebrity mansions as inspiration for a smaller-scale cinema room project of their own.