Estela Ayala Armchair September 02nd, 2018 - 01:16:47
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
As a result, we're sometimes forced to poke at devices in the dark, all while finding brightness settings that strike the delicate balance between readability and how much it disturbs our sleeping partners. We could always move off the bed, but what's more comfortable than a bed in a bedroom? An armchair could be a close second. It's a wonder more people don't have comfortable seating in their bedrooms for this very scenario.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
For a smaller space, this really is crucial. You want to be sure to have enough room to sit down comfortably in the chair, while also ensuring it fits in the area. The smallest you need to look at for seat depth (or inner measurements) is approximately 24 inches wide for comfortable seating. Take external sizes too, so you will know your chair will slot in perfectly to the space you've got reserved for it.
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.
This chair has a very simple construction. It consists simply of four panels which slot together to give a stable assembly. Despite its simplicity, its lines are as stylish as any manufactured chair and will complement any living room.