Home / Armchair / Mid Century Armchair / Modulares Mid Century Sofa Von Rud Thygesen Johnny Sorensen Fuumlr Modulares Mid Century Sofa Von Rud Thygesen Johnny Sorensen Fuumlr Magnus Olsen Durup 1960er
Jennifer Kirkland Armchair September 02nd, 2018 - 19:05:43
The armchair in the bedroom helps with a very 21st century issue - the quandary of laptop, tablet or phone use in bed while your partner is trying to sleep.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
This chair has a very simple construction. It consists simply of four panels which slot together to give a stable assembly. Despite its simplicity, its lines are as stylish as any manufactured chair and will complement any living room.
Provided both side panels have been cut to exactly the same size, there is no reason why you should not clamp them together with all edges flush and cut out paired slots at the same time.
Why restrict ourselves, though? There are a number of rooms that armchairs would easily fit into, and in fact, there are a number of use cases that are crying out for armchairs above all else. With handcrafted furniture companies (see below for an example), you have ample options to tailor an armchair to those specific environments. No need to worry about your armchair looking like it's been pulled straight out of the living room and is being held somewhere else temporarily.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Bath rugs area rugs wool blanket neck pillow patio table chaise lounge recling sofa best sectional sofa porch swings vanity lights lite neon signs black table runner tv stand.