Toni Velez Armchair November 07th, 2018 - 21:54:07
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
The conservatory as TV-less living room argument is persuasive though. Perfect for entertaining guests before dinner, or even for day-to-day reading, web browsing, or just for sitting down with a cup of coffee and looking out at the scenery. You could start with an armchair, and then add other living room accoutrements if the armchair trial proves successful and desirable.
Should the armchairs for sale you're taking a look at are to be alongside a sofa, then you want to leave at least 2 feet between them. You also want to leave at least two feet between the armchair and coffee table to stop banging the knees each and every time you stand up!
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Laundry hamper area rugs baby blanket neck pillow storage bench chaise with sleeper ottoman table best sectional sofa wall sticker vanity lights lava lamps table runner 43 inch tv stand.