Bette Wagner Armchair September 05th, 2018 - 07:32:47
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
For a smaller space, this really is crucial. You want to be sure to have enough room to sit down comfortably in the chair, while also ensuring it fits in the area. The smallest you need to look at for seat depth (or inner measurements) is approximately 24 inches wide for comfortable seating. Take external sizes too, so you will know your chair will slot in perfectly to the space you've got reserved for it.
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
You also need to ensure that you measure the outer dimensions of a piece of furniture - when you are limited for space, it is the outer dimensions that are going to be the important ones. It is as well to remember that whatever the outer measurements of your armchair are, the interior measurements are going to be smaller - so make sure you will have enough room to actually be comfortable when sitting in the armchair.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
If you trawl through the enormous array of different styles that the various manufacturers, you may notice that most armchairs seem to lack in originality. The problem with many designers is they seem to forget people have to sit in the chairs and it's the act of sitting that inspires the design of the chair... not the other way around. Furthermore, the armchair is designed to be sat in with comfort in mind: where backs, buttocks and arms should be supported ergonomically to take the pressure off the muscles across the shoulders and lower neck.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Comforter sets floating shelves wool blanket neck pillow patio table sleeper sofa ottoman table best sectional sofa porch swings salt lamps lite neon signs best table runner 43 inch tv stand.