Kathie Hendrix Armchair September 03rd, 2018 - 23:04:36
Planning your decor according to the size of your space is critical, no matter whether the room is large or small. Home furniture needs some space in between it to ensure proper room flow, traffic flow and safety.
Some of the most comfortable furniture pieces are the ones that have been in your home for several generations. They exude a welcoming and lived-in ambiance to which people easily resonate. A rococo armchair in the living room may resemble the chair that your great grandmother sat on in the black and white photograph hanging on the wall of memories. This brings a vivid sense of nostalgia that compels you to look back to the past. Furniture pieces made long ago have a valuable history attached to them. Resting in an antique armchair that was passed down through several generations, you can let your imagination take you away to those earlier times and make connections with those who sat upon that very chair as the decades passed.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
It is possible to have cushions made up for you by professionals, but they are easy to make yourself from rubber and the covering of your choice.
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of the construction processes, great care should be taken.