Lilian Ware Armchair November 03rd, 2018 - 00:18:35
The conservatory as TV-less living room argument is persuasive though. Perfect for entertaining guests before dinner, or even for day-to-day reading, web browsing, or just for sitting down with a cup of coffee and looking out at the scenery. You could start with an armchair, and then add other living room accoutrements if the armchair trial proves successful and desirable.
The seat panel has two slots cut in it, corresponding to those cut in the front edge of the side panels. Each slot is located 64mm from and parallel to the short sides and is 368mm in length.
This chair has a very simple construction. It consists simply of four panels which slot together to give a stable assembly. Despite its simplicity, its lines are as stylish as any manufactured chair and will complement any living room.
One answer to the problem, which has been developed over the last few years, is furniture which can easily and quickly be stowed away when not in use. Nowadays it is possible to buy inflatable chairs, and more conventional chairs which can be assembled or dismantled in a matter of seconds. It is on this latter principle that the knock-down chair has been designed.
Wood is used for the basic frame. Pine or some other softwood is suitable, but a satisfactory and cheaper alternative is 16mm plywood. As with most manufactured materials, there are different grades of plywood and you should choose a high quality type, such as Finnish birch, which takes a very good painted finish on both surfaces.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Bathroom light candle holders blanket pillow storage bench chaise with sleeper ottoman table sectional sleeper sofa porch swings best salt lamps lite neon signs table runner tv stand.