Jackie Copeland Armchair September 01st, 2018 - 21:26:45
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
In the modern trend the armchair has become an important piece of furniture along with the sofa and other furniture that you buy to decorate your house. Purchasing the armchair requires special consideration as it will not only add to the beauty of the room but will also provide comfort and relaxation when you recline in it to watch your favorite show on the television or read the newspaper or just relax after a tiring day.
The chair itself has to be in comparative proportion to your room you're placing it in. If you've got a large area, with heavy furniture, then a compact, thin-armed chair will appear delicate and out of place. If you've got a small room, then an armchair that's got thick arms and curved features will overpower all of your furniture. Either way, a room will appear and feel off-balance.
A great rule of thumb is the fact that the bigger your space, the 'heavier' your armchair could be (and the other way round). A study covered with walls of book shelves and wood panels can accommodate a heavy, dominating chair. Look at armchairs for sale who have rich detailing and more classic design. For a more modern space, especially a smaller space, look for free standing legs and slimmer arm rests, and straight, clean lines.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.