Evangeline Duffy Armchair August 25th, 2018 - 09:47:30
As a result, we're sometimes forced to poke at devices in the dark, all while finding brightness settings that strike the delicate balance between readability and how much it disturbs our sleeping partners. We could always move off the bed, but what's more comfortable than a bed in a bedroom? An armchair could be a close second. It's a wonder more people don't have comfortable seating in their bedrooms for this very scenario.
Be it an email you just need to send that night, or some last minute present buying or travel arrangements, our lives are increasingly ruled by devices, and at the same time, we're increasingly expected to be accessible and available all hours of the day.
The size of a chair needs to be taken into consideration when you don't have a great deal of room to manoeuvre. When you are considering armchairs for small spaces you might consider a smaller version of a standard chair. This should be between 24 inches and 32 inches wide - usually ample room to allow somebody to be seated comfortably. Never leave sizing to chance, hoping that it will slot into that rather neat little place you have planned for it. You need to be ruthless with measurements - make sure you measure the space you have and the furniture you want to fill it with.
There is a danger that this chair might end up being used as an incredibly luxurious shoe fitting point, however. If you don't think anyone in your family is likely to actually read under the stairs, the armchair may end up being more decorative than functional - which might not be a problem for you, depending on your circumstances.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
First tale the two side panels and cut out the angled rear edge. To do this accurately, mark a line 25mm from the rear edge, then draw a line diagonally from opposite corners. Provided your two side panels match exactly in size, you can clamp them together and cut along the diagonal line to give a matching pair.