Faye Poole Armchair July 06th, 2018
As a result, we're sometimes forced to poke at devices in the dark, all while finding brightness settings that strike the delicate balance between readability and how much it disturbs our sleeping partners. We could always move off the bed,...
Shelby Mann Armchair August 12th, 2018
A continuing trend in modern furniture design has been the sacrificing of comfort for economy and space. While agreeing that those huge Victorian armchairs were really luxurious, designers today would argue that they would be very much out of place...
Priscilla Farmer Armchair August 12th, 2018
Wood is used for the basic frame. Pine or some other softwood is suitable, but a satisfactory and cheaper alternative is 16mm plywood. As with most manufactured materials, there are different grades of plywood and you should choose a high...
Terry Albert Armchair August 12th, 2018
If you trawl through the enormous array of different styles that the various manufacturers, you may notice that most armchairs seem to lack in originality. The problem with many designers is they seem to forget people have to sit in...
Marla Flowers Armchair August 12th, 2018
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length 165mm. and are located 64mm. from, and parallel to, the short sides....
Evangeline Duffy Armchair August 12th, 2018
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs...
Lilian Ware Armchair August 12th, 2018
Cut out all the pieces to the sizes given in the cutting list, taking care that the two side panels match exactly. These pieces now have to be cut to patterns and as this work represents the major part of...
Eliza Nieves Armchair August 12th, 2018
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw...