Evangeline Duffy Armchair September 03rd, 2018 - 15:06:14
Planning your decor according to the size of your space is critical, no matter whether the room is large or small. Home furniture needs some space in between it to ensure proper room flow, traffic flow and safety.
Provided both side panels have been cut to exactly the same size, there is no reason why you should not clamp them together with all edges flush and cut out paired slots at the same time.
You also need to ensure that you measure the outer dimensions of a piece of furniture - when you are limited for space, it is the outer dimensions that are going to be the important ones. It is as well to remember that whatever the outer measurements of your armchair are, the interior measurements are going to be smaller - so make sure you will have enough room to actually be comfortable when sitting in the armchair.
Two slots corresponding to those cut in the top edges of the side panels are made in the back panel. They are the same length - 165mm and are located 64mm from, and parallel to, the short sides, and is 368mm. in length.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
Now mark and cut out the slots which house the back panel. These are 165mm long, 13mm wide, and run at an angel of 82° to the top edges of the side panels. Use the methods detailed above to mark and cut them accurately.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Laundry hamper candle holders blanket neck pillow deck box chaise with sleeper ottoman table best sectional sofa wall sticker vanity lights neon signs best table runner best tv stand.