Bette Wagner Armchair August 30th, 2018 - 00:48:22
A vacant space under a set of stairs can easily be transformed into a reading area with the addition of an armchair, and little else. It's a simple, cost-effective change - no shelving, carpeting and so on necessary. You just need to fit in with the colour scheme of your hall.
Perhaps the greatest limitation on furniture design is the smallness of modern houses. To be comfortable, a chair must not only be well designed, constructed and padded, but also it must be fairly large. As few people can afford the space for a large suite of furniture, armchairs become increasingly smaller.
Now cut the slots in the side panels. There are two on each: one houses the back panel and the other houses the seat panel. Make the slot for the seat panel first. This slot, which is 16mm wide, runs at angle, from a point about halfway down the front edge, to a point 368mm from the front edge. To mark it in exactly, first draw a point on the front, short edge, 267mm from the top long edge. With a protractor set at 86° mark in the angle at which the seat panel meets the front edge of the side panel. Then use the two marked points to draw in a line extending 368mm from the front short edge of the side panel. This line marks the proposed location of the upper surface of the seat panel. To mark out the correct width of the slot, draw another point 16mm from that already marked on the front short edge of the side panel and, with the aid of a protractor, draw another line parallel to the first and 16mm from it.
You also need to ensure that you measure the outer dimensions of a piece of furniture - when you are limited for space, it is the outer dimensions that are going to be the important ones. It is as well to remember that whatever the outer measurements of your armchair are, the interior measurements are going to be smaller - so make sure you will have enough room to actually be comfortable when sitting in the armchair.
Use a tenon saw to cut the slot, following the rules on correct sawing techniques given in most DIY manuals. If you cut exactly to the marked lines, you will make the slot slightly too wide. Instead, position the saw so that one face is just inside and parallel to the line. When you have cut down the lines, cut out the short edge of the slot with a jig saw or chisel.
Why restrict ourselves, though? There are a number of rooms that armchairs would easily fit into, and in fact, there are a number of use cases that are crying out for armchairs above all else. With handcrafted furniture companies (see below for an example), you have ample options to tailor an armchair to those specific environments. No need to worry about your armchair looking like it's been pulled straight out of the living room and is being held somewhere else temporarily.
Copyright © 2019 scalabeyond.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Bath rugs candle holders baby blanket neck pillow storage shed sleeper sofa ottoman chair sectional sofa porch swings vanity lights lite neon signs best table runner 43 inch tv stand.